 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
FUEL PRESSURE SWITCH
Preparatory Steps
If the unit already has a fuel pressure switch installed that is connected to a lamp
on the dash, the switch and fitting must be replaced with these components.
The wire that was connected to the original switch will be connected to the ECM.
NOTE: If the unit does not have an additional lamp installed on the dash, a generic LED can
be purchased and install for use with this kit
Install Banjo Fitting
Remove the banjo fitting and sealing washers from the fuel filter housing outlet.
Install the tapped banjo fitting and new sealing washers in the fuel filter housing outlet.
Torque Value: 24 N.m [18 ft-lb]
Preparatory Steps
If the unit already has a fuel pressure switch installed that is connected to a lamp
on the dash, the switch and fitting must be replaced with these components.
The wire that was connected to the original switch will be connected to the ECM.
NOTE: If the unit does not have an additional lamp installed on the dash, a generic LED can
be purchased and install for use with this kit
Install Banjo Fitting
Remove the banjo fitting and sealing washers from the fuel filter housing outlet.
Install the tapped banjo fitting and new sealing washers in the fuel filter housing outlet.
Torque Value: 24 N.m [18 ft-lb]
| Telephone 1-901-380-9290 |